Dodge 75 Manuale di installazione

Sfoglia online o scarica il pdf Manuale di installazione per Alimentazione Dodge 75. Dodge 75 2.

Stampa la pagina

Installation Manual for DODGE Model 75 Power Supply

These instructions must be read thoroughly before installing or operating this product.

WARNING: Only qualified electrical personnel familiar with

the construction and operation of this equipment and the

hazards involved should install, adjust, and/or service this

equipment. Failure to observe this precaution can result in

bodily injury.

WARNING: The user is responsible for conforming to the

National Electrical Code and all other applicable local codes

in respect to wiring practices, grounding, disconnects,

and overcurrent protection. Installation of an approved

disconnecting means in the line side of the controller is of

particular importance. Failure to observe these precautions

could result in severe bodily injury or loss of life.

WARNING: Subsequent steps require rotating parts and/or

electrical circuits to be exposed. Stay clear if unit must be

running or disconnect and lockout or tag power source if

contact must be made. Failure to observe these precautions

could result in severe bodily injury or loss of life.

WARNING Because of the possible danger to persons(s) or

property from accidents which may result from the improper

use of products, it is important that correct procedures be

followed. Products must be used in accordance with the

engineering information specified in the catalog. Proper

installation, maintenance and operation procedures must

be observed. The instructions in the instruction manuals

must be followed. Inspections should be made as necessary

to assure safe operation under prevailing conditions. Proper

guards and other suitable safety devices or procedures as

may be desirable or as may be specified in safety codes

should be provided, and are neither provided by Baldor

Electric Company nor are the responsibility of Baldor

Electric Company. This unit and its associated equipment

must be installed, adjusted and maintained by qualified

personnel who are familiar with the construction and

operation of all equipment in the system and the potential

hazards involved. When risk to persons or property may

be involved, a failsafe device must be an inegral part of the

driven equipment beyond the speed reducer output shaft.

Specifications

Input voltage: 230 VAC 50-60 Hz, 1 phase

Output voltage: 100 VDC Nominal

Output current: 0.4 Amp Maximum

Output wattage: 80 Watts Maximum

Dimensions: 0.62" H, 1.40" W, 0.90" D

Description:

Model 75 is a power supply that can be mounted in a

Clutch and/or Brake conduit box. The power supply

converts 230 VAC to 100 VDC.

Model 67 power supply kit includes:

Model 75 power supply (quantity 1)

Two-sided tape (quantity 1)

Wire nuts (quantity 4)

Connection Instructions (See Figure 1):

Disconnect and lockout power to the Clutch and/or Brake

unit.

Remove conduit box cover and separate the incoming

power leads to the coil(s).

Connect power supply as shown in Figure 1, using supplied

wire nuts to secure connections.

Note A: Polarity of wiring is immaterial.

Note B: Customer must supply any switching or fuse for

230 VAC input line voltage.

Note C: The power supply is suitable for clutches and

brakes rated 90 VDC.

Use two-sided tape to secure power supply to the inside

wall of the conduit box.

Reattach the conduit box cover making sure not to pinch

wiring.

blue

230

Vac

blue

* Clutch coil lead wires are black.

Brake coil lead wires are white.

Figure 1 - Wiring Diagram

red

coil

black