Dogtra YS 200 Manuale d'uso
Sfoglia online o scarica il pdf Manuale d'uso per Prodotto per la cura degli animali domestici Dogtra YS 200. Dogtra YS 200 2. No bark collar
Anche per Dogtra YS 200: Manuale d'uso (8 pagine), Manuale d'uso (12 pagine)
Stampa la paginaProduct Safety and Health Statement
1. The YS200 is intended to prevent the barking of
dogs only. It is NOT intended for use on people or on
animals other than dogs. Dogtra does not assume any
liability for the improper use of the YS200.
Owner's
2. Leaving the YS200 in the same position on a dog's
Manual
neck for over 8 hours at a time can cause skin
irritation. Occasionally reposition the unit so the
contact points are moved to a different location on
the dog's neck. Dogtra is not responsible for skin
irritation caused by the prolonged usage of the
YS200.
3. A proper fit is necessary for the YS200 to work
optimally. Both contact points must be in contact
with your dog's skin at all times for a consistent
By Dogtra No Bark Collars
stimulation. A loose fitting collar can cause the
contact points to rub against the skin and cause
irritation.
4. The YS200 is not intended for use on dogs less than 1
year old.
5. Remove the YS200 before playing with your dog. The
activity may cause your dog to bark, which could
lead to the association of playing to the electrical
stimulation.
6. Closely monitor your dog's activity and stimulation
output while using the YS200. When attaching or
removing the YS200 from your dog's neck, make
sure your dog is not barking and in a calm or stable
condition.
At a Glance
YS200
13mm
Owner's
(2)Coin Lithium
No Bark
Contact
Manual
Batteries
Collar
(3V CR2032)
Points
Overview
Contact
Battery Cover
Points
Collar Strap
ON/OFF and
Intensity Dial
LED Indicator Light
Main Features
6
Intensity
Replaceable
Battery
Levels 1-6
3V
3V
Reduced Size
Vocal Cord
Collar
Sensor
Water Resistant
For Dogs as
Receiver
Small as 5 lbs
How to Use the On/Off & Intensity Dial
The ON/OFF and
Intensity Dial is used to
+
turn the YS200 on and
-
off, and to select the
intensity level. Set the
dial to OFF to turn off
the YS200. Set the no bark collar to (1) for the lowest
stimulation setting and (6) for the highest stimulation
setting.
NOTICE
Start with the lowest level of stimulation and work your
way up. An appropriate level is when your dog responds
to the stimulation with a mild negative reaction, such as a
jerking or tensing of the neck muscles.
Testing the YS200
1. Turn the intensity dial to
level 2 or 3.
2. Use the cap end of
a ballpoint pen and
repeatedly tap between
the contact points.
3. The unit is working once
the LED indicator blinks. Wait 2 seconds and tap again.
4. The unit is in normal working condition when the LED
indicator blinks again. The LED indicator will only
blink when the unit is activated.
Replacing the Batteries
*Turn the unit off before attempting to replace the batteries.
- Use a coin to unscrew the battery cover counterclockwise.
- Insert two batteries with the plus sides facing out
(both batteries must be facing the same direction).
- Replace the battery cover by screwing it in clockwise. Be
sure to place the batteries with the '+' sides facing up and
out. To remove the batteries, remove the battery cover
and tap the batteries on the palm of your hand.
+
-
Batteries