Clockaudio CRM 203 RF Manuale di installazione

Sfoglia online o scarica il pdf Manuale di installazione per Microfono Clockaudio CRM 203 RF. Clockaudio CRM 203 RF 1.

The CRM 203-RF is a tri-element boundary layer through table condenser microphone, with a built-in mechanism that will

allow the user to make the microphone disappear without having to physically remove it from the table. This is achieved by

simply pressing the top of the microphone downwards until it locks; then by pressing the microphone again it will raise itself

back to its original position above the surface of the table. Engineered in high quality brass with built in shock mount and RF

filter.

Securing Nut

Mic B + C

Black Cables

Mic A White cable

Grey 2 core (red and blue wires) is to be used for remote

switching, screen is not used. Also note switch is open

circuit when the mic is down. Please take note program-

ming will be needed on the DSP side to allow the micro-

phone to be muted once retracted.



Offering 3 independently wired mics a + b + c



Fitted with a magnetic reed switch designed to prevent unwanted feedback from

retracted microphones on power up. The switch contact is closed (ON) when the

microphones are in the raised position and open (OFF) when retracted. This is not

designed to be used for privacy muting.



Easy to install



Low profile at surface level



Unique ability to lock capsules away from sight when not in use



Robust brass construction



Cardioid polar pattern



Built in RF filter



Balanced output



Supplied with 3 x 2m (6.6ft) 2 core + screen audio cable and 1 x grey 2 core cable

for internal reed switch



Satin Nickel (CRM 203N-RF) or Black Nextel (CRM 203-RF) finish

Installation Guide

Drill a 58mm (2.25") hole through the

table see fig A.

Remove the nut and fit the CRM 203-RF

through the 58mm (2.25") hole see fig B.

Replace nut and tighten to the under-

side of the table see fig C.

Connections for each mic a + b + c will

be identified as follows: mic a (in line

with screws) uses white cable, mic b + c

have black sleeves and are positioned

90° from mic a: Red Phase +, White

Phase – and screen Ground.

Using p-clamps provided fix cables to

the underside of the table ensuring

there is sufficient slack in the cable loom for the mic

to operate. See fig D.

CRM 203 RF

Fig D