Clockaudio CDT100 Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Accessories Clockaudio CDT100. Clockaudio CDT100 17. Dante transporter
Anche per Clockaudio CDT100: Manuale d'uso (16 pagine)

Stampa la pagina

CDT100 User Manual

6 – Mounting

Installation of the CDT 100 is very straight forward.

It is recommended that the unit be secured to a flat surface with a screw through each mounting flange.

Dimensions for mounting are show in the Figure 9 below.

Use a No. 6 screw of a type and size that is applicable to the surface to which the CDT100 will be attached.

Figure 9

- Mounting Information

All connections to the CDT 100 should be made before the power is applied.

 Attach any audio sources that will be used to the inputs. The inputs are balanced so be sure to check what output type the

source to be connected uses in order to find how to connect it correctly . (see Hardware Connections section).

When powering, using an optional external supply:

 Attach either Dante I/F port to a spare port on the Dante network switch using a CAT 5 cable.

 Attach the power supply to the power input jack and then power up the external supply.

If all steps are performed correctly, the power light on the front should be lit. There may also be some activity on the CDT 100

Dante I/F LED indicators.

With no Dante network, both LEDs will remain off.

If an active connection is made, both LEDs will come on and if there is network activity, the yellow LED will

flash.

Clockaudio 2015