DogWatch Hidden Fence System Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Prodotto per la cura degli animali domestici DogWatch Hidden Fence System. DogWatch Hidden Fence System 15.
Anche per DogWatch Hidden Fence System: Manuale d'uso (14 pagine)
Stampa la pagina
BOUNDARY WiRE
The boundanj wire creates the perimeter for the DogWatch Hidden Fence System, and
can enclose any area larger than 1/4 acre. It can be buried 3-4" beneath the suiface of
the yard or can lie on top of the ground (e.g.: in wooded or rocky areas). It can also be
installed around gardens or swimming pools, or attached to an existing fence to prevent
your dog from digging under or jumping over it.
FIGURE C.
BOUNDARY WiRE FMmI~s
Boundary Wire: The boundary wire canies the coded radio signal around the perimeter
of your property.
Signal Field: The radio signal is transmitted from the boundary wire in all directions, it
can be used to keep dogs in or out of an area. The signal is adjusted by the Range con
trol on the Transmitter to create a signal field on each side of the wire. The recommended
width is 8-10 feet. It is important when planning your installation to avoid sharp corners
and bottlenecks which may cause overlapping (and confusing) signals.
Continuous Loop: In order for the system to work properly, the boundary wire must
form a continuous loop. Any break in the wire will cancel the signal field. If the bound
ary wire is broken or unplugged, the green Loop indicator light will go out and an
audible warning* will sound. To locate the break, inspect the route of the boundary
wire for signs of disturbance. Most breaks are caused by lawn/garden equipment. If
you cannot locate the break, contact your Authorized Dealer for service.
Twisted Wire: When the boundary wire is "twisted' the radio signal is canceled and that
portion of the wire does not affect the receiver collar. Wire can only be twisted between
the transmitter and the boundary wire, and between the boundary wire and additional
loops around a garden or pool (see Figure C).
Splicing: it is important that your splices be waterproof, as shown below.
Boundary Wire
Surge Protector: This part of the system protects the transmitter from damage due
to lightning power surges. it is attached to the existing electrical source house ground
or a grounding rod (not provided) and then connected to the twisted wire between the
transmitter and the boundary wire. It is important that you have a proper ground.
Transmitter
~'
&Surge
Splice
Twisted
it
Splice
Boundary Wire
PLEASE REMEMBER
• Keep the transmitter and receiver collar out of reach of children.
• Never attempt to service the transmitter yourseit
• Be sure your transmitter and surge protector are properly grounded.
• Place the receiver collar on the dog so that the battery cap faces downward.
• Fit the collar snugly around your dog's neck.
• When changing contact posts, use the supplied DogWatch collar wrench to
avoid damage from over-tightening. Broken contact posts are not warrantied.
• Make sure that battery is fresh and is inserted correctiy...POSITIVE END FIRST.
• Never attempt to service the receiver yourself.
• Make sure the boundary wire forms a continuous loop.
• Avoid sharp corners or bottlenecks in the boundary wire.
• Train your dog as outlined in this manual.
• Never adjust the transmitter while your dog is wearing the receiver collar.