CYP PUV-2606RX Manuale operativo - Pagina 9
Sfoglia online o scarica il pdf Manuale operativo per Ricevitore CYP PUV-2606RX. CYP PUV-2606RX 20. Hdbaset to hdmi receiver with usb connectivity
Stampa la pagina6.2 Rear Panel
ON
OFF
DC 24V
SERVICE
1
2
1
DC 24V Port: Plug the 24V DC power adapter into this port and
connect it to an AC wall outlet for power.
2
SERVICE Switch: This switch is reserved for factory use only. The
default setting is "OFF".
3
BYPASS RS-232 Terminal Block: Connect to a PC, laptop, or serial
controllable device with a 3-pin adapter cable for the extension of
RS-232 signals between both ends of the HDBaseT connection.
4
IR OUT Port: Connect to the provided IR Blaster to transmit IR signals
from the other end of the HDBaseT connection to devices within
direct line-of-sight of the IR Blaster.
IR IN Port: Connect to the provided IR Extender to receive IR control
signals and extend them to devices connected to the other end of
the HDBaseT connection. Ensure that the remote being used is within
direct line-of-sight of the IR Extender.
5
CAT 5e/6/7 IN Port: Connect to a compatible HDBaseT Transmitter
with a single Cat.5e/6/7 cable for reception of all data signals. PoH will
also be supplied to a connected compatible PD Transmitter.
6
HDMI OUT: Connect to HDMI TVs, monitors or amplifiers for digital
video and audio output.
7
Analogue OUT Terminal Block: Connect to powered speakers or
an amplifier for balanced analogue stereo audio output. This will
output the independent audio channel sent by compatible HDBaseT
Transmitters.
8
LAN Port: Connect to an Ethernet supporting device or to your local
network, as appropriate, to extend the network to both ends of the
HDBaseT connection.
BYPASS
TXRX
RS-232
IR OUT
IR IN
3
4
L
CAT 5e/6/7 IN
HDMI OUT
ANALOGUE OUT
5
6
R
LAN
7
8
4