CYP PU-507-KIT Manuale operativo - Pagina 9
Sfoglia online o scarica il pdf Manuale operativo per Estensore CYP PU-507-KIT. CYP PU-507-KIT 16. V1.4 hdmi over single cat5e/6 hdbaset 5play, single lan, set (up to 100m)
Anche per CYP PU-507-KIT: Manuale operativo (11 pagine)
Stampa la pagina
6.2 Receiver Front and Rear Panels
Front
HDMI Out
1
2
1
HDMI Out: Connect to a HDMI equipped TV/monitor for display of the
HDMI input source signal.
2
LAN: Connect to a PC or Laptop to the Internet or network
connection.
3
RS-232 Out: Connect to the device that is to be controlled (via D-Sub
9 pin female cable) by RS-232 commands.
4
Power LED: This blue LED will illuminate when the device is
connected to a power supply.
5
IR 2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the
equipment to be controlled.
6
IR 1 Extender: Connect to the supplied IR receiver cables for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR extender.
7
Link LED:The yellow LED will illuminate when both the input and
output signals are connected through the CAT cable. When it blinks
regularly it indicates the source is NOT sending a signal to the
transmitter but the transmitter and receiver are linked. If it blinks
irregulaly it indicates an error has occurred.
8
CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6
cable for tranmission of all data signals.
Receiver
RS-232 Out
CAT5e/6 to HDMI with LAN/IR/RS232
3
Rear
IR2 Blaster
Power
IR1 Extender
5
4
6
7
8
9