Ashford TURBO KIT POLYCORD Istruzioni
Sfoglia online o scarica il pdf Istruzioni per Strumenti e accessori per la tessitura Ashford TURBO KIT POLYCORD. Ashford TURBO KIT POLYCORD 2. For all single drive spinning wheels
Stampa la pagina
FOR ALL ASHFORD SINGLE DRIVE SPINNING WHEELS
The polycord drive belt will give you and your wheel a boost.
•
Makes treadling easier with low drive belt tension
•
Less friction on the wheel and flyer bearings
•
More traction, especially on the smaller flyer whorls
•
Easy drive belt adjustment - set and forget
•
Makes plying a breeze, especial with chunky yarns.
Here's how you fit your new Turbo kit:
1.
Ensure the maiden bar is set to it's lowest point. Place the polycord
drive belt around the wheel and largest pulley on the flyer.
2.
Mark the polycord where it is just the right length without
stretching it. Note: Do not make it tight.
3.
Cut off the excess polycord with a razor blade, sharp knife or
scissors and save it for future repairs or adjustments.
4.
Before joining, place the cord back around the wheel.
5.
Hold the two ends close to the base of the flame of a candle or
gas lighter until the ends start to melt. The flame at the base is
cleaner and results in a clear joint.
6.
Then quickly press the ends tightly together in the groove in the
wooden fusing block. Hold firmly for about 30 seconds or until
the polycord has cooled.
7.
Use a razor blade or nail clippers to trim off the excess material
around the joint.
8.
Adjust the tension knob so the polycord tension is as loose as
possible without actually slipping.
Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone 64 3 308 9087
[email protected] www.ashford.co.nz
TURBO KIT POLYCORD