Ashley EC95 Manuale di installazione e funzionamento - Pagina 2

Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Stufa a legna Ashley EC95. Ashley EC95 20. Wood burning circulator heater
Anche per Ashley EC95: Manuale di installazione e funzionamento (20 pagine), Manuale di installazione e funzionamento (20 pagine)

These instructions comply with the applicable

Standards for the installation and operation of this type heater. Before beginning the installation, you should check with

local building officials to assure compliance with local regulations and codes.

This heater is safety listed by Warnock Hersey International, Inc. as specified by the listing label attached to the heater.

The chimney draft draws in combustion air through an adjustable air inlet thermostat located inside the cabinet. Air

flows through and across the bed of fuel, causing the fire to progress through the fuel bed. Heat is transferred to the air

that flows between the cabinet and the firebox. Any attempt to alter this air by connecting this heater to a duct system

or air movement fans other than the optional KB902 listed blower, available from your heater dealer, can lead to im-

proper and possibly hazardous operation of this heater.

When selecting a location for the heater, be sure attention is given to the following considerations:

1. If the heater is to be vented into a Listed High Temperature Type HT Factory-Built Residential Type And

Building Heating Appliance Chimney, review the installation instructions for the chimney to comply with

requirements for proper chimney location, height, space requirements, etc.

2. If the heater is to be vented into a masonry chimney, the heater should be located as near the chimney as pos-

sible without failing to comply with the requirements for minimum spacing between the chimney connector,

heater and combustibles. (Be sure chimney is constructed according to NFPA standards.)

3. The location of the heater must provide at least the minimum clearances between the heater, chimney connector

and combustible materials as specified by figures 1, 2, 3, 4.

4. If the heater is to be located on a combustible floor, there must be suitable floor space to install a floor protector

beneath and extending beyond the heater as shown by figure 5 and as described by the Floor Protection

section of this manual.

5. The heater should be located centrally within the area where heat is desired but out of traffic areas to minimize

the likelihood of persons accidentally contacting the hot surface of the heater.

6. The heater should be located away from doorways and central heat outlets and inlets to reduce the chance of

drafts blowing smoke, ashes or sparks out of the heater during refueling or ash removal.

7. The heater should be located where a small supply of wood may be kept conveniently close but not within 36

inches of the heater.

8. Locate the heater so that drapes, curtains, furniture and other combustible materials will not be closer than the

clearances shown by figures 1, 2, 3, and 4 OR install a clearance reduction system. See MINIMUM CLEAR

ANCES TO COMBUSTIBLE WALLS AND CEILINGS section of this manual for details.

FIGURE 1 - MINIMUM CLEARANCES

TO COMBUSTIBLES

BUILDING CODES AND SAFETY STANDARDS

National Fire Protection Association and Underwriters' Laboratories, Inc.

FIGURE 2 - MINIMUM CLEARANCES TO

COMBUSTIBLES

EC95