Ashly Protea NE4250.25 Manuale operativo - Pagina 6

Sfoglia online o scarica il pdf Manuale operativo per Amplificatore Ashly Protea NE4250.25. Ashly Protea NE4250.25 16. Network enabled multi-channel power amplifiers
Anche per Ashly Protea NE4250.25: Manuale operativo (16 pagine), Manuale operativo (16 pagine), Scheda tecnica (2 pagine), Specifiche tecniche (2 pagine), Manuale operativo (16 pagine), Manuale operativo (20 pagine), Manuale operativo (20 pagine)

Stampa la pagina
Ashly Protea NE4250.25 Manuale operativo
Operating Manual - NE Multi Channel Power Amplifier

Physical Description

Each model in the NE Multichannel series is 2RU, and weighs 22 pounds (10kg) or less. The model number is indicated
in the lower left corner of the front panel.
Amplifier Front Panel
1. Mounting Holes – For rack mounting.
2. Power Switch – Switches the unit on or off. Note: The power switch can be disabled from Protea
3. Status LEDs – Indicate status of: Power, Standby, Protect, Power Switch Disable, and Comm activity
4. Air Inflow Vents – Cool air enters here
5. Channel Controls – Channel control area
6. Signal LEDs – The lowest LED will begin to light when the output voltage reaches -18dBu below rated output.
The Clip LEDs will begin to flash when output voltage is 1/2 volt below the output power supply voltage.
7. Bridge – This LED indicates that the channel pair is selected to BRIDGE mode from the back panel switch, and
that only the odd input channel level control is active
8. Temp and Current LEDs – The Temp LED indicates that the amplifier has reached an excessively high
operating temperature. The Current LED confirms that the amplifier output is delivered to a speaker load.
9. Channel Attenuators – These control the input signal level to the amp, and can be disabled from software.
10. Factory Reset – To reset all internal configurations (including passwords) back to their original factory settings, press
and hold this recessed front panel tact switch during power up until all channel LEDs are lit. Upon reset completion, the LEDs
will turn off and the amp will be in normal operating mode.
Amplifier Rear Panel
6
ne
Software