Ashly MX-406 Manuale operativo - Pagina 10

Sfoglia online o scarica il pdf Manuale operativo per Mixer musicale Ashly MX-406. Ashly MX-406 12. Stereo microphone/line mixer
Anche per Ashly MX-406: Manuale operativo (12 pagine), Note tecniche e specifiche (2 pagine), Manuale operativo (12 pagine), Manuale operativo (16 pagine)

Ashly MX-406 Manuale operativo
Operating Manual -MX-406 Stereo Microphone/Line Mixer
8.3 Excessive Noise
If the noise is in the form of hiss, the problem is usually due to an input stage set for insufficient gain and then compen-
sating for it by increasing the level . Try increasing gain and reducing level . Also, check that the -20dB rear panel pad switch
is not unnecessarily enabled .
8.4 Excessive hum
This is usually caused by "ground loops" in the system wiring . A complex sound system with many sources separated
by significant distance and using several power outlets has many opportunities for this problem to occur . If possible, feed
everything in the system from one power source with a common ground . Use balanced input and output connections between
widely separated components .
If you need help, get in touch with your Ashly dealer or call an Ashly technical service representative .

9. SPECIFICATIONS

DISTORTION
THD at +4dBu output, 20Hz-20KHz . . . . . . . . . . . . . . . . . <0 .05%
THD at +12dBu output, 30Hz-10KHz . . . . . . . . . . . . . . . . <0 .05%
IMD (SMPTE) at +12dBu output . . . . . . . . . . . . . . . . . . . . <0 .05%
HUM & NOISE (20Hz-20KHz at max preamp gain)
equivalent input hum and noise . . . . . . . . . . . . . . . . . . . . <-128dBu
residual output noise
all levels at minimum . . . . . . . . . . . . . . . . . . . . . . . . . . . <-100dBu
master levels at nominal
all channel levels at minimum . . . . . . . . . . . . . . . . . . . . . . <-90dBu
aux master at nominal
all channel aux at minimum . . . . . . . . . . . . . . . . . . . . . . . . <-90dBu
master levels and one
channel level at nominal . . . . . . . . . . . . . . . . . . . . . . . . . . <-68dBu
MAXIMUM VOLTAGE GAIN (±2dB)
MASTER
Mic/Line Input to Master Outputs . . . . . . . . . . . . . . . . . . . . . +84dB
Mic/Line Input to Mono Output, 600 ohm load . . . . . . . . . . +84dB
AUX SENDS
Mic Input to Aux Master Output, pre ch . level . . . . . . . . . . . . 84dB
Mic Input to Aux Master Output, post ch . level . . . . . . . . . . . . 97dB
Stereo Line In to Master Output . . . . . . . . . . . . . . . . . . . . . . . 27dB
FREQUENCY RESPONSE
20Hz-20KHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .+0 .5/-1 .0dB
EQUALIZATION
Bass
. . . . . . . . . . . . . . . . . . . . . . . . . ±12dB at 70Hz, shelving
Treble
. . . . . . . . . . . . . . . . . . . . . . . . . ±12dB at 8KHz, shelving
CROSSTALK
adjacent inputs, 20Hz-20KHz . . . . . . . . . . . . . . . . . . . . . . . <-65dB
10
VU METERS
Stereo outputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -21 to +6 VU
0VU = +4dBu
PEAK INDICATORS
Peak Clip indicator on each input channel and left and right outputs,
illuminates 3dB below clipping
PHANTOM POWER
+48 VDC applied to all Mic Inputs, switchable on rear panel . Maxi-
mum total current draw = 80mA . Maximum single channel current
draw = 14mA . Gradual power-up and down to eliminate "pops" .
SHIPPING WEIGHT
13 lbs . (5 .9kg)
POWER REQUIREMENTS
100-240 VAC, 50-60 Hz, 30 watt
DIMENSIONS
19" x 3 .5" x 9 .4" (483mm x 89mm x 239mm)
*unless otherwise stated, specification conditions are: 150Ω
source, maximum preamp gain, all other controls set at nomi-
nal, XLR output into 600Ω or greater.