Ashly ne8800 Manuale operativo - Pagina 12

Sfoglia online o scarica il pdf Manuale operativo per Hardware del computer Ashly ne8800. Ashly ne8800 20. Network enabled dsp processor
Anche per Ashly ne8800: Manuale operativo (20 pagine), Specifiche tecniche (3 pagine), Manuale (20 pagine)

Stampa la pagina

Operating Manual - ne8800, ne4800, ne4400 DSP Processor

(10.1 WR-5 continued)

Programming of each WR-5 button is done after the WR-5 is wired to its host NE processor through the remote data connector

and the NE processor is networked to a PC running Protea

represented with its own software control surface. Click the <Identify Remote> button to find a physical WR-5. For more than four

WR-5 remotes, the Ashly RPS-18 power supply must be used . Note that a jumper (J3) must be placed on the last and only the last

WR-5 in series, even if there is only one WR-5 being used (see previous drawing) .

10.2 RD-8C or RW-8C Remote Fader Control

A second microprocessor based desktop controller, the

Ashly RD-8C (or RW-8C wall mount), is an eight channel level

controller that uses slide faders for individual channel and master

level control and mute . The RD-8C is wired to the four pin Data

Input euroblock connector on the back panel . Only one RD-8C

can be wired to a NE processor . NOTE: When an RD-8C is used,

no other serial data type remotes can be used.

In the software DSP section, a remote gain function must

be placed in any input or output and then assigned to one of the

RD-8C slide faders for remote level control of that channel . The

RD-8C uses an XLR jack, while the RW-8C uses a euroblock

connector to wire to the NE processor (see wiring diagram) .

10.3 WR-1 Remote DC Level Control

Individual input or output channels can have remote level

control using a potentiometer assembly such as the Ashly WR-1

and four conductor bell wire . The WR-1 is a dual potentiometer

remote volume control designed to fit in a standard US electrical

wall box . Each volume control is connected to a terminal block

on the WR-1 circuit board, which is then wired to the processor

back panel euroblock connector labeled "5VDC Remote Con-

trol" as shown . Do not connect the WR-1 remote level control

ground to any other external grounds.

10.4 WR-1.5 Level and Preset Recall (not shown)

The WR-1 .5 offers a four position rotary switch for preset

recall along with a single potentiometer for DC level control .

See our website for further details .

10.5 WR-2 Pushbutton Preset Recall (not shown)

The WR-2 offers four pushbutton switches for recalling de-

vice presets by wiring to the NE processor logic inputs and assign-

ing them preset recall function . See our website for WR-2 details .

software. Each WR-5 has its own identifying property and is uniquely

Ashly RW-8C Remote Level Controller

Ashly WR-1 Remote DC Level Controller