Ashly Protea NE8250.25 Manuale operativo - Pagina 9

Sfoglia online o scarica il pdf Manuale operativo per Hardware del computer Ashly Protea NE8250.25. Ashly Protea NE8250.25 16. Network enabled multi-channel power amplifiers
Anche per Ashly Protea NE8250.25: Manuale operativo (16 pagine), Specifiche tecniche (2 pagine), Scheda tecnica (2 pagine), Manuale operativo (16 pagine), Manuale operativo (16 pagine), Manuale operativo (20 pagine)

Ashly Protea NE8250.25 Manuale operativo
Operating Manual - NE Multi Channel Power Amplifiers
The WR-5 is a microprocessor based remote
control unit which can be used with the NE multi-
channel amplifiers. The WR-5 is designed to fit into
a standard electrical wall box. Up to four WR-5
remotes can be phantom powered from one ampli-
fier, and adding more remotes is possible using an
external power supply. Each of six buttons on the
WR-5 can be programmed to engage one of the fol-
lowing functions:
1) Preset recall
2) Preset scroll
3) Channel volume
4) Channel mute
5) Zone input source selection (requires DSP)
Programming of each button is done from Pro-
tea Software when the WR-5 is wired to its host NE am-
plifier, and the amplifier is connected to a PC via ethernet.
Up to four WR-5 units can be daisy-chained from the same
amplifier. See your Ashly dealer or visit the Ashly web
site at www.ashly.com for more WR-5 details.
RD-8C or RW-8C Remote Control
A second microprocessor based controller, the Ashly
RD-8C, is an eight channel wall mount level controller
that uses slide faders for individual channel and master
level control and mute. NOTE: When an RD-8C is used,
no other microprocessor based remotes can be used.
WR-1 Remote Level Control
Individual amplifier channels can have remote level
control using a potentiometer assembly such as the Ashly
WR-1 and four conductor wire. The WR-1 is a dual po-
tentiometer remote volume control designed to fit in a stan-
dard wall electrical box. Each volume control is connected
to a terminal block on the WR-1 circuit board, which in
turn must be wired to the amplifier back panel euroblock
connector labeled "Remote Level Control" as shown. Do
not connect the WR-1 remote level control ground to any
other external grounds.
Ashly WR-5 Remote Control
Ashly RD-8C Remote Control
Ashly WR-1 Remote Attenuator
G
CV-2
+5
G
CV-1
+5
9