Ashly Protea WR-5 Manuale operativo

Sfoglia online o scarica il pdf Manuale operativo per Hardware del computer Ashly Protea WR-5. Ashly Protea WR-5 6. Ne product remote control
Anche per Ashly Protea WR-5: Nota di rilascio (1 pagine), Manuale operativo (4 pagine)

Stampa la pagina

Ashly WR-5 NE Product Remote Control

1. Introduction

The WR-5 is a microprocessor based remote control unit for most Ashly NE products. Com-

patible products currently include Pema amplifiers, ne8800 and ne4800 system processors, the

ne24.24M matrix processor, and all models of the NE multichannel (four or eight channel) power

amplifiers. Additional products may become available in the future. Using Protea NE software,

six function select buttons and two parameter adjust buttons are available to control a limited range

of assigned functions within their host product. Up to four WR-5 units can be daisy-chained and

phantom powered from one NE product, and even more can be added using an in-line power supply

adapter such as the Ashly RPS-18. Note: If a WR-5 is used with a NE host product, no other serial

communications devices, including the Ashly RD-8C, may be used with that product.

The WR-5 is designed to fit into a standard electrical wall box. Electrical connections to the

host unit are made using a four conductor low gauge wire terminated with euroblock connectors.

There is also a two pin jumper labelled "J6" which requires the provided female jumper to be in-

stalled in specific situations (see section 2). Note: The WR-5E is the functional equivalent to the

WR-5, designed to fit into European electrical boxes. A standard decora plate (not included) can

be purchased separately to cover the WR-5 electrical box and

satisfy the aesthetic needs of the instal-

lation.

Note: Avoid static shock disrup-

tions to connected devices by mounting

the WR-5 to an earth-grounded metal

wall box, or by earth-grounding a metal

decora plate. This prevents any static

discharge from flowing through the data

lines.

Each of six buttons on the WR-5

can be programmed through Protea NE

Software to engage one of the following

functions (if available): preset recall,

preset scroll, gain control, channel en-

gage/mute, zone source selection, logic

output active high, logic output active

low, and matrix mixer, with a green

LED next to each button to display active status. To the right of each button is a pocket in the mylar

overlay for a paper function label to be inserted. The two other buttons are used to adjust function

parameters, indicated by the LED display.