Bluerock Tools PTK-300 Manuale operativo - Pagina 15

Sfoglia online o scarica il pdf Manuale operativo per Strumenti Bluerock Tools PTK-300. Bluerock Tools PTK-300 20. Pipe threading kit for pd- 300/ptm-300

Stampa la pagina

P T K - 3 0 0

P I P E

T H R E A D I N G

General Maintenance

SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.

DON'T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!

Inspect electrical cords and electrical connections if using optional PD-300 power drive.

Keep machine clean and free of debris.

Check for misalignment, binding and breakage of all moving parts. If damaged, repair tool before use.

Check the cutting blade on the pipe cutting assembly.

Clean dies and inspect for chips. Also check the sharpness on the dies. If they are dull or broken, replace ALL dies

with identical set.

Clean chuck teeth with wire brush if using optional PD-300 power drive. Check the attrition of the claw points on the

3-jaw chuck. If the points are worn, replace with identical piece.

Proper lubrication is essential to trouble-free operation and long life of the optional PD-300 Power Drive. Grease

main shaft bearings every 2 to 6 months depending upon amount of Power Drive use. Grease fittings are provided

on side base, one at each end of shaft. Use a good grade of cup grease.

After each use coat all working surfaces with corrosion resistant oil.

Check brushes for wear and replace if worn if using optional PD-300 power drive.

K I T

Note

Chapter