Bluerock Tools SDS200 Manuale operativo - Pagina 15

Sfoglia online o scarica il pdf Manuale operativo per Apparecchiature per la pulizia Bluerock Tools SDS200. Bluerock Tools SDS200 17. Sectional drain cleaning machine

Stampa la pagina

S D S 2 0 0

P I P E

D R A I N

General Maintenance

SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.

DON'T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!

Inspect electrical cords and electrical connections.

Keep machine clean and free of debris.

Flush cables with water after each use. Occasionally lubricate cables and couplings.

Check for misalignment, binding and breakage of all moving parts. If damaged, repair tool before use.

Check the cutters for sharpness or damage.

Clean clutch teeth with wire brush. Check the attrition on the 3-jaw clutch. If the points are worn, replace with

identical piece.

After each use coat all moving parts (including clutch driver) with corrosion resistant oil.

Occasional Maintenance

Check brushes for wear and replace if worn.

Grease rocker arms and main bearings every 3-6 months.

Grease main bearings thru grease fitting inside clutch handle slot.

After a lot of use, clutch jaws may need to be replaced.

Remove the screws that hold the front guard to the housing. Remove screws that hold the nosepiece on.

Slide out clutch driver and replace jaws.

Put nosepiece assembly and guards back on.

After a lot of use, the V-Belt may need to be tightened.

Remove V-Belt Guard

Loosen locknut, turn bolt until V-Belt tightens. Tighten lock nut back up. Replace guard.

C L E A N E R

Note

WARNING: DO NOT operate machine with guards removed.

Chapter