d&b audiotechnik Z5552 Istruzioni per il montaggio - Pagina 5

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Supporto per TV d&b audiotechnik Z5552. d&b audiotechnik Z5552 8.

Intended use

Example of 60° setting on the Angle connector

d&b Z5552 Mounting instructions 1.1 en

1.3 Intended use

The d&b Bracket connector must only be used to connect two d&b

horizontal brackets, e.g. Z5388 VP Horizontal bracket, as

described in these mounting instructions.

The Bracket connector can be:

▪ flown using a flying adapter with variable vertical and

horizontal alignments.

▪ mounted to poles using a TV spigot with a heavy duty pipe

clamp.

Note: Refer to the specific mounting instructions for assembly

and operation of these accessories.

The Angle connector consists of two parts and is used to set

different angles for an array. Angles can be set in steps of ten in

the range from 20° to 50° and from 25° to 55°. As shown in the

graphic opposite, positions [1] and [2] on the Angle connector

parts are the master holes for the

Angle settings

To set an angle on the Angle connector, proceed as follows:

1. Choose an angle according to your system requirements.

2. Insert screw [3] into the desired angle hole on part 1 of the

Angle connector.

3. Take part 1 with screw [3] and screw it into master hole [1]

or [2] of part 2 of the Angle connector for either

uneven [1] angles (depending on your angle selection).

↳ Handtighten the screw.

4. On part 2 of the Angle connector, insert screw [4] into the

same angle hole you selected for the screw on part 1. This

angle hole corresponds to one of the two master holes of part

↳ Handtighten the screw.

Both parts of the Angle connector now show the same hole

pattern.

even or the uneven angles.

even [2] or