BlueSky Mast 350G XL Series Scheda di riferimento rapido - Pagina 6
Sfoglia online o scarica il pdf Scheda di riferimento rapido per Sistemi di sollevamento BlueSky Mast 350G XL Series. BlueSky Mast 350G XL Series 10.
Anche per BlueSky Mast 350G XL Series: Riferimento rapido (10 pagine)
Stampa la pagina
74
Incremental guying. This may be
required to deploy the last few
mast poles.
77
Lower the lift base plate, insert a
mast pole and raise it until the
poles nest together.
81
Repeat this process until you
reach the last center mast pole.
86
Helpful Hint: If there are high winds or you are having difficulty holding /
locking the rope into place, one person can hold the guy rope in front of
the handle and the other person can lock the guy rope into place.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2016 Allendale LLC All Rights Reserved
350G XL - Lift Series
Quick Reference Sheet - Primary & Secondary Guying
1 ft.
75
Incremental Guying: Loosen the guy ropes based on the length of the mast pole below the cam lock.
EXAMPLE: If the length of the pole under the cam lock is one foot - slide the handle back one foot on each of the
four primary guy ropes. This will allow you enough room to raise the mast pole.
78
One at a time, slowly loosen the primary guy ropes by holding the guy
rope in front of the handle and sliding the handle back approx. four feet
Doing this will give you enough slack to add another mast pole.
82
Lower the last center mast pole to
the ground and lock the cam
lock.
DEPLOYMENT
83
Adjust the 4 primary guy ropes
and make sure the mast is straight
and perpendicular.
87
Adjust and lock the four secondary
guy ropes.
Read Manual Before Use
Refer to detailed instructions in the
350G XL Lift Series Manual at all times
79
NOTE: The mast will lean, but will
straighten up as you raise the next
mast pole.
84
Lock the primary guy ropes by pulling a small amount of slack in. Use
your finger and loop the guy rope over the two hooks of the guy handle.
Pull the guy handle towards the mast to remove any slack in the rope.
88
Drive two stakes into the two holes
on the lift base plate and make
sure the cam lock is lock.
1"
76
Raise the mast until one inch is
showing below the cam lock and
lock the cam lock.
80
Release the cam lock and raise
the mast until the four primary
guy ropes go taut.
85
89
Deploy the surface wire ground-
ing kit at this time (if required)