Ambient Technologies RCSITEA Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Telecomando Ambient Technologies RCSITEA. Ambient Technologies RCSITEA 12. Thermostatic on/off, flame height adjustment and blower remote control 120 vac

Stampa la pagina

Optional 6 Hour Shutdown:

The receiver comes preset from the factory with a 6 hour shutdown from its last ON or flamer lower

operation. This is done to prevent the appliance from continuing to run if unattended.

You may disable this feature if you wish. To disable, change the receiver privacy (DIP) switch #1 to the

OFF position. Make sure the transmitter privacy (DIP) switches are set the same as the receiver. Follow

the instructions on how to set the privacy (DIP) switch setting.

By disabling this feature, your appliance may continue to run unattended.

Optional Wall Cover Plate:

1. Receiver snaps into wall cover plate. The wall plate is mounted by using 2 screws provided.

Light your gas appliance following the appliance lighting instructions that came with the appliance.

Confirm that the pilot light is on; it must be in operation for the remote control to operate the main gas

valve and blower. Appliance control knob must be in the ON position, and appliance ON/OFF switch must

be in OFF position.

Slide the 3 position button on the remote receiver to the ON position and the main gas flame should ignite.

Slide the button to OFF and the main gas flame should extinguish, but the pilot light will remain on.

Slide the button to RS (the center position), then press the ON button on transmitter to turn the system ON.

The main gas flame should ignite and blower should come on after the On Delay Time is reached and fan

speed you desire is selected.

Press the OFF button on transmitter to turn the system to OFF. The flame should extinguish (the pilot light

will remain on) and blower should be off after the Off Delay Time you set.

Symptom

1. Battery icon on

LCD on transmitter.

2. LCD display is

blank

3. LCD display shows

"funny" display

4. Appliance does not

come on.

5. Receiver cannot

50D0111

RCSITEA Installation & Operating Manual

Rel 1.0 April 2009

TESTING YOUR NEW REMOTE CONTROL SYSTEM

TROUBLESHOOTING

Causes

1. Low Battery

1. Wiring / Electrical Connections

2. Privacy (DIP) switch setting on transmitter

does not match receiver

3. Transmitter measures temperature exceeding

99 degrees Fahrenheit and shows "HI" on LCD

4. Distance between the transmitter and receiver

is more than 30 feet

1. Receiver is installed in an enclosure

1. Replace batteries. Change

2. Check battery installation or

3. Press Reset button at the back of

1. Slide the switch to ON, if

2. If appliance does not come on,

1. Make sure the transmitter and

1. Move transmitter to a cooler

1. Make sure the operating distance

1. Make sure the receiver is not

Page 10 of 10

A Division Of Monessen Hearth Systems

Action

batteries every 6 months.

replace batteries.

the transmitter.

appliance comes ON, wiring is

not the cause.

check wiring connections.

receiver have the same DIP

switch settings.

place and wait until temperature

drops below 99 degree.

is less than 30 feet

Ambient Technologies