Ambient Weather WS-40 Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Termometro Ambient Weather WS-40. Ambient Weather WS-40 7. Wireless indoor / outdoor thermometer

(1) temperature

(2) temperature units ( °F vs. °C)

(3) channel number

7. Close the battery door. Make sure the gasket (around the battery compartment) is properly

seated in its trace prior to closing the door. Tighten the set screw.

2.3 Display Console Set Up

Note: To avoid permanent damage, please take note of the battery polarity before inserting the

batteries.

Move the remote thermometer at least 5' away from the display console (if the sensor is too close, it

may not be received by the display console). Remove the battery door on the back of the display.

Insert two AA (alkaline or lithium) batteries in the back of the display console, as shown in Figure 4.

All of the LCD segments will light up for a few seconds to verify all segments are operating properly.

The IN status bar will continuously flash once per second to confirm proper operation.

Replace the battery door, and fold out the desk stand and place the console in the upright position.

The console will instantly display indoor temperature. The outdoor temperature will display dashes

or --.-, then update on the display within a few minutes.

If the remote sensor does not update, please reference the troubleshooting guide in Section 6.

Version 1.0

Figure 3

Page 3