Asko T130 Manuale d'uso e manutenzione - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Piano cottura Asko T130. Asko T130 12. Asko t120 cooktop: user guide

Stampa la pagina

building-in

preliminary notes

please note:

gas connection RC 1/2"

}

(ISO 7/1-RC 1/2)

A nipple 1/2" (ISO 228-1-G 1/2A) is

supplied for those countries where it is

required.

The fitting of the appliance should only be

carried out by registered Corgi gas fitter.

The type of gas in the country for which the

appliance is equipped is stated on the data

plate.

This appliance must be installed by an

authorized person.

This appliance shall be installed in

accordance with the manufacturers

installation instructions, local gas fitting

regulations, municipal building codes,

electrical wiring regulations, AS5601 /

AG601 - Gas installations and relevant

statutory regulations.'

The appliance is not suitable for connection

with a flexible hose.

There are two ways to carry out the

connection to the main gas line:

A. The hotplate can be connected with rigid

pipe as specified in AS5601 table 3.1.

B. The hotplate can be connected with a

Flexible Hose, which complies with

AS/NZS 1869 (AGA Approved), 10 mm

ID, class B or D, no more than 1.2 m long

and in accordance with AS5601. Ensure

that the Hose does not contact the hot

surfaces of the hotplate, oven,

dishwasher or other appliance that may

be installed underneath or next to the

hotplate.

building-in

preliminary notes

warning:

please note:

electrical connection

warning:

}

Ensure that the hose assembly is restrained

from accidental contact with the flue or flue

outlet of an underbench oven. The hose

should not be subjected to abrasion,

kinking or permanent deformation and

should be able to be inspected along its

entire length. Unions compatible with the

hose fittings must be used and connections

tested for gas leaks. The supply connection

point shall be accessible with the appliance

installed.

Before operating the appliance, check the

gas connections with a soap/water mix for

any leaks.

240 V a.c., 50 Hz - 0.6 Watt

This hotplate is supplied with a plug &

cord. Simply plug into a 3 pin household

socket outlet which is properly earthed.

In order to avoid hazard, any electrical work

performed on this equipment or its

associated wiring, should only be done by

persons authorised by the supplier or

similarly qualified persons.

If the supply cord is damaged, it shall be

replaced by the manufacturer or its service

agent or similarly qualified person in order

to avoid a hazard.

The socket outlet for this hotplate shall be

installed near the hotplate and shall be

easily accessible.