- ページ 9
電気ヒーター Ambirad Vision VSXのPDF サービス＆コミッショニング・マニュアルをオンラインで閲覧またはダウンロードできます。Ambirad Vision VSX 14 ページ。 Radiant tube heaters
ページを印刷するStep 5 The turbulators should be cleaned with
a soft brush.
Step 3 If required the interior of the tubes can
then be cleaned using an industrial vacuum
cleaner or by using long poles and a scraper.
Step 4 Refit components.
3.8 Heat exchanger Servicing
Step 1 Remove the flue connections
Step 2 Slacken casing support screws and
remove heat exchanger from the radiant tube.
Step 3 Remove any dust and dirt from the
heat exchanger & refit.
3.9 Reflector Servicing
The condition of the reflectors should be noted.
If necessary the reflectors can be cleaned with a
mild detergent. This can significantly improve
the efficiency of the appliance.
3.10 Sweeping of Flue
Inspect the fresh air inlet duct and vent to
ensure they are free from any blockage or
obstruction. The air inlet terminal and vent
terminal should be inspected to ensure they are
not liable to obstruction.
3.11 Recommissioning After Service
After
servicing
of
undertaken,
it
re-commission the heater as detailed in Section
3 of these instructions.
9
the
heater
has
will
be
necessary
been
to