- ページ 6

ストーブ ACR Electronics Tenbury TEN1MFのPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。ACR Electronics Tenbury TEN1MF 17 ページ。

ページを印刷する

Tenbury insert install manual 1015-3 03/12/2015 09:57 Page 6

Minimum Builders

Opening

For ease of installation the builders

opening may be made slightly larger

than the appliance dimensions, please

see diagram opposite.

The construction of fireplace recess

should be of a suitable non-combustible

material such as brick or concrete

blockwork, and have a minimum

thickness of 200mm to the sides and

rear of the appliance, unless it is a back

to back recess within the same property.

Please refer to building regs document J

for more information.

Clearances to

combustible materials

Installation into a false

chimney breast

All parts of the false studwork chimney

must be constructed of a non-

combustible material i.e. metal

studwork.

Do not use combustible materials within

the chequered area (150mm to the sides

of the appliance and 300mm to the rear

of the appliance).

Do not fill the area surrounding the

appliance with insulating material, the

void around the appliance must be

ventilated to prevent a buildup of excess

heat.

There must be minimum ventilating area

at both high and low levels of 50 cm²

each, the vents should take ambient air

from the room in which the appliance is

150mm

installed and return the warm air back

into the same room environment.

Consideration should also be taken to

provide adequate access to the

connecting flue for service and

maintenance purposes.

384mm

560mm

420mm

150mm