- ページ 6

ストーブ ACR Electronics The Buxton BX1MFのPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。ACR Electronics The Buxton BX1MF 20 ページ。

Installation Instructions

CO Alarms

It is required by building regulations that whenever a new or replacement

wood/solid fuel or biomass appliance is installed in a dwelling a carbon

monoxide alarm to BS EN 50292:2002 must be fitted in the same room as

the appliance.

The alarm should be install according to the alarms manufacturers

instructions and should not be considered a substitute for the appliance

being installed incorrectly or regular maintenance of the appliance or flue

system

Location of the unit

Clearances to non-combustible materials

There must be a minimum clearance of 150mm at each side of the

appliance. A clearance of 150mm is required at the back of stove (if the

rear wall has a thickness of 200mm or more this measurement can be

reduced to 50mm) A minimum clearance of 150mm is required above the

appliance.

Clearances to combustible materials

There must be a minimum clearance of 600mm at each side and 750mm

at the rear of the appliance from any combustible materials. If using

single wall flue pipe, there must be a clearance of at least 3 times the

diameter of the flue pipe (e.g 125mm diameter pipe = 375mm minimum

clearance) from any combustible materials e.g wooden beam.

Curtains and soft furnishings should be a minimum of 1m away from the

appliance.

Adequate space should be provided for servicing the appliance.

We do not recommend that plasma televisions and expensive artwork are

hung over the fireplace.

Please remember that this appliance has been designed to provide heat

and if installed into a recess enough space should be left around the

appliance to enable the heat produced to rise and escape from the

recess back into the room.