- ページ 12

海上ラジオ ACR Electronics PATHFINDER 3 SART (SEARCH AND RESCUE TRANSPONDER)のPDF 製品サポートマニュアルをオンラインで閲覧またはダウンロードできます。ACR Electronics PATHFINDER 3 SART (SEARCH AND RESCUE TRANSPONDER) 19 ページ。 Search and rescue transponder (sart)

ページを印刷する

9.0

Vessel Mounting

To deploy SART on board a distressed vessel, rather than a life raft, hang SART near

vertical as high as possible, with a clear view of the horizon. The SART must not be

obscured by metal bulkheads etc.

Installation

The SART should be mounted inside the vessel, next to an emergency exit. Some ships

require 2 SARTs one by a port exit and one by a starboard exit. Mount each SART as

follows . . .

•

Mount in plain view, at a convenient height, so that all crew can easily remove the

SART.

•

Position at least 1 meter from the ship's compass.

The SART mounting bracket should be bolted to a bulkhead using four (4) suitable M6

(1/4") bolts. The equipment does not include mounting hardware for the bracket, as it will

depend on the bulkhead material and its thickness. Bracket mounting holes and SART

mounting details are shown in figure 7.

To install SART:

Remove SART from its packaging and check for shipping damage.

Perform the SART test (see Testing and Maintenance procedures on page 15).

Select a position for SART Mounting allowing sufficient space for the assembly.

Drill holes to dimensions shown on figure 7.

Place bracket in position and secure to bulkhead as follows:

Remove the SART from the bracket.

Position bracket at the correct position for maximum visibility

Mark position of bracket fixing holes.

Drill holes to suit mounting fixtures.

Secure bracket to bulkhead.

Mount SART on the bracket (see figure 7).

Secure SART with Velcro strap.

NOTE: The SART contains magnetic material.

Ensure that the position that you select is at least 3 feet

(1 meter) away from compass installations.

Y1-03-0170 Rev. B