- ページ 2
医療機器 Ambu aScope 3 LargeのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Ambu aScope 3 Large 2 ページ。 Ascope 3 family
ページを印刷する
4.
Preparation for use
•
The aView
TM
can be placed on a flat surface or secured to an I.V. pole using the
bracket supplied. The bracket also has a hook that facilitates easy, accessible
storage of the aScope
TM
3 via the hole in the top of the aScope
•
Most users find the default contrast and brightness settings to be optimal but
these can be adjusted if required.
•
Consider dimming the room lights to see the image from the aScope
•
Check the battery indicator on the aView
for the procedure charge the monitor by plugging it into the mains.
5.
Icons
Real time image will
appear after only a
few seconds.
After appr. 45 seconds
the user Interface is
ready displaying the
icons for battery status,
brightness/contrast
control, device usage
time as well as the as
snapshots and
recording of videos.
6.
Insertion of the aScope
•
The tube connection can be used
to fixate the selected ET tube during
intubation.
•
Keep the cord of the aScope
straight as possible by holding the
handle of the aScope
3 high. This
TM
increases the range of movement of
the tip and allows you more control.
•
Advance the aScope
3 slowly,
TM
allowing the light intensity of the
camera to re–adjust.
7.
Removal procedure
•
Slowly withdraw the aScope
The distal tip must be in a neutral and non–deflected position.
•
After use disconnect the aScope
accordance with local guidelines for collection of infected medical devices
with electronic components.
•
Wipe down the aView
as per the instructions in the Instructions For Use.
TM
Ambu A/S
Baltorpbakken 13 • DK-2750 Ballerup • Denmark
T +45 72 25 20 00 • F +45 72 25 20 50
www.ambu.com
TM
. If the time remaining is not sufficient
Start–up picture
When the aView
turned on the ON/OFF
button will light up
green. During charging
the ON/OFF button will
light orange.
3
TM
•
If the image is affected by blood or
secretion you can try to clear the
secretion by flicking the bending lever
up and down or dabbing the camera
3 as
TM
tip gently against the mucosal wall to
clear the image.
•
If the above fails, remove the aScope
and rub the lens clean with either
gauze or an alcohol swap. Do not be
afraid to exert a little pressure when
doing this. Proceed as above.
while observing the image on the monitor.
TM
from the aView
and dispose of it in
TM
TM
TM
3 pouch.
TM
3 more clearly.
Max. battery status
of the aView
TM
TM
is
Battery is charging
If the battery is fully charged and still
connected to a charger the battery
icon changes to:
TM
Min. batte ry
The icon remains white until one block is
status of the
left, after which it turns red.
aView
TM
When remaining battery capacity is 10%
the red battery icon starts flashing.
Charging is shown with blocks flashing.
Battery current
Current capacity is shown with non-
capacity
flashing blocks.