- ページ 5

おもちゃ Flitework Extra 300LPXのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Flitework Extra 300LPX 13 ページ。

Take care, that no glue comes inside the hinges. Be careful especially with PU glue, because its volume is

growing up during hardening. Glue inside the hinges becomes a big problem for their movement.

Assembling and installation of the tailgear:

Screw the aluminium bow of tail gear to the tail of

the fuselage like you can see on the picture.

Therefore you should use 3 mm wood screws.

Assemble the mechanical parts of the tail wheel

hub and fix all screws with blue locking agent.

Installing the power system:

The installation of electric- or gas power system is very similar. For a lot of gas engines are plywood templates

added to the model accessories. For DLE 111 motor use the template of DA 100 or the paper template in this

manual. Also you can find the template for TB-5000 electric gear motor at the end of this manual.

About 16 cm away from the pivot axis of the

rudder drill a hole for the linkage ball, which is used

for the steering of the tail wheel.

Shorten the 2mm linkage steel wire to a length,

that it is impossible for the steel wire to slip out of

the linkage ball even if the rudder is in max. De-

flection.

Bead the linkage ball onto the 2 mm steel wire and

glue it into the prepared hole of the rudder blade.

Use 10 min. Epoxy glue.

Take care for a good mobility of all parts.

- 5 -