- ページ 4

リフティングシステム Floe PWC1300のPDF クイック・スタート・ガイドをオンラインで閲覧またはダウンロードできます。Floe PWC1300 8 ページ。 Anchoring system
Floe PWC1300 にも：組立説明書 (12 ページ)

Plastic end caps

Side Frame

Rear Frame

Beam

3/8" x 2" bolt

Leveling Leg

Side Frame

Fig. 1B

Front Frame

Beam

Fig. 1

Slide clamp tight

against locating plate

Sheet 4 of 8

Unscrew 3/8" x 3/4" bolt from leveling legs.

Lay side frames on side. Insert leveling

legs into corner posts making sure the nut

track lines up with lower hole in corner post.

Line up the nut and washer with the hole in

corner post and fasten with 3/8" x 3/4" bolt

that were removed from leveling legs. Leave

leveling leg extended out 8". See Fig. 1 Torque

to 40 ft. lbs.

Clamp front and rear frame beams to side

frames using 3/8" x 2" bolts and nylock nuts.

Torque to 40 ft. lbs. Frame beams to be

located as shown in Fig. 1A and 1B.

3/8" x 3/4"

Adjusting bolt

Fig. 1A

Front Frame Beam

Step 1

IMPORTANT NOTE:

Be sure that the drainage holes in the

frame beams are on the bottom at

time of installation.

Slide clamp tight

against locating plate

Fig. 1B

Rear Frame Beam