- ページ 2

水ポンプ FLOJET 04325343AのPDF マニュアルをオンラインで閲覧またはダウンロードできます。FLOJET 04325343A 4 ページ。 Quad ii diaphragm automatic washdown pump

ページを印刷する

Fresh Water

Tank

INSTALLATION

STEP 1

Remove shipping plugs from Quad pump ports. Some

water from factory testing may spill out.

STEP 2

Install inlet A and discharge B port connectors. Firmly

push slide clips C forward to lock port connectors in

place.

STEP 3

Slide rubber mounts D fully into 4 mounting tracks.

STEP 4

Mount pump vertically, with pump head down or

horizontally in an accessible location. If mounting

D.C. WIRING

STEP 1

Use 14 gauge stranded wire to 20', 12 gauge to 50',

from power source.

STEP 2

Use a 15 amp rated on-off switch on the (+) positive (red)

motor lead.

Flojet

Washdown Pump

Flojet Inlet

Strainer

Seacock

Red (+)

Fuse

Thru Deck

Fitting

"Y" Valve

vertically, motor up, attach motor mounts first, then

pump head mounts while supporting weight of pump.

STEP 5

Use 3/4" or 5/8" I.D. flexible hose (preferably braided or

reinforced). Use hose clamps on the slip-on barb hose

connectors.

STEP 6

Install a 40 mesh in line strainer in accessible location

between tank and pump inlet.

Black (–)

Switch

STEP 3

Install fuse protection in the positive lead. 12V use

15 amp fuse, 24V use 7 amp fuse, 32V use 5 amp fuse.

NOTE: The 115 Volt model may be plugged directly into

a 115V a.c. electrical outlet. A G.F.I. (ground fault interruption)

outlet and switched circuit is required near water.

(+)

(–)

Battery