- ページ 2
コントロールユニット Flomatic MiniairのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Flomatic Miniair 2 ページ。 3/8” thru 2” air release valves
ページを印刷するAir Release Valves
Model Miniair® 3/8" thru 2"
Disassembly / Reassembly:
®
The Miniair
can be disassembled without removing it from the line. No special tools are required.
1.
Close shut-off valve, open the drain then remove the cover bolts.
2.
Remove the cover (float assembly is attached to the cover and may be removed for
ease of inspection).
3.
Clean and inspect all parts.
4.
Replace any parts that exhibited wear or damage.
5.
Re-attach float assembly (if removed) to cover.
6.
Re-attach the cover to valve – do not over torque the bolts.
7.
Place valve back in service.
Problem:
Valve drains hard while testing
Leaking at inlet connection
Leaking around the cover
Leaks when closed
Orifice not venting air
Information needed to order repair parts:
Valve Model Number
Valve Size
Valve working Pressure
Limited One Year Warranty: Flomatic valves are guaranteed against defects of material or workmanship
when used for the services recommended. If, in any recommended service a defect develops due to material
or workmanship, and the device is returned, freight prepaid, to Flomatic Corporation within 12 months from
date of purchase, it will be repaired or replaced free of charge. Flomatic Corporations' liability shall be limited
to our agreement to repair or replacement of valve only.
Trouble Shooting Guide
Flomatic Valves, 15 Pruyn's Island, Glens Falls, New York 12801
Phone: 518-761-9797
Fax: 518-761-9798
Installation Instructions
Possible Solutions:
Orifice may be plugged – disassemble valve and
flush debris from orifice.
Tighten valve connection. If valve still leaks
remove valve from system and re-attach with
new Teflon® tape or liquid Teflon®.
Tighten bolts – max. 20 lbs Do Not Over Torque
Flush valve to remove debris. If valves still leaks
disassemble valve, inspect and replace used or
wore parts. Rubber should be replaced if wore or
every 5 years.
Make sure the operating pressure is not
exceeded. If not disassemble valve, inspect and
replace used or wore parts.
www.flomatic.com
Flomatic Corporation
miniair
Rev. D