- ページ 5

ツール AME Intl. Combi 11010のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AME Intl. Combi 11010 8 ページ。 Tire bead breaker

DANGER

Always stand to one side of the rim when using the bead

breaker. Standing to one side of the bead breaker allows

you to maintain control of the bead breaker.

Do not hold the bead breaker when breaking the tire bead.

If it is not seated properly and flies off the rim, the bead

breaker could cause serious injury or death.

5. Continue to apply hydraulic pressure until the bead breaking ram ex-

tends about 1/2 - 3/4 inch [13-19 mm] from the bead breaker. (See Fig.

7.)

NOTE: Never try to break the tire bead with only one push. Instead, pro-

ceed to "Continuing to Break the Tire Bead" below.

Continuing to Break the Tire Bead

1. Move the bead breaker 8-12 inches [0,2-0,3 m] from its current posi-

tion.

2. Repeat steps, starting with "Positioning the Bead Breaker", until the rim is completely separated

from the tire bead.

Breaking the Bead on the Other Side

1. Turn the tire over on the other side.

2. Repeat all steps, starting with "Positioning the Tire Bead" on page 2.

DANGER

Failure to chock the wheels and crib the vehicle can result in serious injury or death.

MOUNTING AND INFLATION

Jacking Up the Vehicle

1. Chock the wheels opposite the jack.

2. Jack up the vehicle.

3. Crib the vehicle with safety stands or blocking devices after jacking it up. Do not work under an un-

blocked load.

AME INTERNATIONAL

INSTRUCTION MANUAL

- 5 -