- ページ 2

タイヤ交換 AME Intl. 92000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AME Intl. 92000 3 ページ。 Otr e/m bar push tool & o.s.h.a. required restraining device

ページを印刷する
1) Depending on the type of tire crane you are using, you may need to make some small
modifications to the crane hook hole in the end of the crane to accept the #92000 mount bracket
2) When the #92000 bar is attached to the end of the tire crane, it will swing down with the feet
pointing to the ground. As you lift the bar with the crane, insert a lever bar (A) or a tool
(KenTool#T23A) as per Figure 1. As you raise the tire crane, push down on the lever (A) to align
the bar and the feet from 9o'clock to 3 o'clock. Once you have the alignment, release the lever
bar (A) and allow the feet to point towards the ground.
3) Adjust the push feet (B) and (C)
to fit the diameter of the rim. Feet
should rest against the bead seat
band, item (D).
4)
CAUTION: Deflate the tire
Completely and run a wire through
the valve to assure all air is out of
tire.
5)
The #92000 can now be raised into position with the crane and controlled with the lever bar (A).
Using the crane control, apply a slight amount of pressure against the bead seat band to push the
bead seat band back. Hold it back to remove the o-ring and lock ring.
6)
Once you have the o-ring and lock ring removed, proceed with normal bead breaking process
and demounting of tire.
7)
After you have mounted the tire and reassembled the rim assembly, it is time for inflation.
Phone (352) 799-1111 Toll Free (877)755-4263 Fax (352)799-1112
DEMOUNTING
2347 Circuit Way, Brooksville, FL 34604