- ページ 7
レンジ ACR STOVES E1200のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。ACR STOVES E1200 9 ページ。 Electric fireplace insert range
ページを印刷するSETTING THE COLOUR FUNCTIONS
• Press the lamp button
• Lamp 1 is for the rear flame
• Lamp 2 is for the base effect
• Lamp 3 is for the log effect
By pressing the lamp buttons, this will change
the colour of the rear flame, base effect and the
log effect separately.
SETTING THE TIME
• Press the CLOCK SETTING button which will
start the DAY curser to blink. Using the
CLOCK UP and CLOCK DOWN buttons to
set the current day e.g. 1-Monday, 2-Tuesday
etc and press CLOCK SETTING to confirm
the required day.
•The hour setting will now be blinking. Adjust
this by using the CLOCK UP and CLOCK
DOWN to reach the present hour and confirm
by pressing CLOCK SETTING.
•The minute setting will now be blinking. Adjust
as per the hour setting.
App Installation and Smart Control
• Your smart phone / tablet must be
connected to WIFI and the insert plugged
in.
• Use the POWER SWITCH and an orange dot
should appear on the fire screen. Do not use
the STAND BY button to
switch this on.
• Download the ACR Stoves
app
• Open the app and click the
SIGN UP button. If you
already have this App installed for other ACR
electric products then please log in using
your existing details. The App can be used to
operate multiple ACR electric products.
• Input your email address and the App will
send a verification code to your email
address.
• Input the code to create your password.
• Press the Add Device button to add your
device.
ADJUSTING THE TEMPERATURE
While the insert is switched on, use
TEMPERATURE UP and TEMPERATURE
DOWN to set the required room temperature. A
confirmation beep will be audible from the fire.
If the room temperature is already warmer than
the temperature set on the remote control, the
heater will switch off / not come on until the
temperature in the room drops to below that on
the remote control.
ADAPTIVE CONTROL
This works in conjunction with the timer
programme. When Adaptive Control mode is
selected and turned on the fire monitors the
room temperature in relation to the selected
target temperature. If the room temperature is
lower than the selected temperature, the
Adaptive Control facility will instruct the fire to
switch on between 2 to 5 minutes earlier than
the set time this is to ensure that the room is at
the required temperate at the time selected
(please note this may not be possible to
achieve if the room is very large or very cold).
12
• Scan the QR code by touching the SCAN
symbol and scanning the code below
• E-Fire – ADD
• Connecting to your wifi – select your wifi
network & input the password. You need to
select the 2.4GHZ option.
• Establishing a connection – press the
STANDBY button on the appliance and hold
for around 3 seconds. You should see a red
light appear next to the orange dot in the
middle of the fire screen. The red light will be
blinking quickly at roughly 2 times per
second. When prompted by the App, if the
red light in blinking rapidly, press NEXT.
• Adding your device – wait whilst the App
adds the device. Keep the phone/tablet close
to the appliance whilst it is syncing. If this
fails, repeat steps 7,8 and 9.
• Your device has now been added
successfully. You are ready to use the phone /
tablet to operate the insert.
13