- ページ 4

サーバー Coachsound TourMaster-LiteのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Coachsound TourMaster-Lite 14 ページ。 Gps mono/stereo audio server

Coachsound TourMaster-Lite TML2504 User Manual v5.00

1.1.1 HEAD UNIT FRONT VIEW – ELECTRICAL PORTS AND CONNECTIONS

The "Front view" is the side of the TourMaster-Lite with one 6-pin MOLEX plug, 2 RJ45 ports and a USB A/B

(printer cable) port.

Head Unit Connections and Ports Diagram

Figure 1: Head Unit Connections and Ports Diagram (Front View)

1. Power Connection

2. GPS Port – the GPS aerial is connected to this port.

3. USB Port - connect the system to a PC/laptop via USB cable to perform updates to the system.

The USB port is used in conjunction with the Coachsound "Route Builder" software tool to update and

synchronize audio tour commentary for the system (Refer to the "Coachsound RouteBuilder Quick-Start

Guide").

4. CPANEL – the Driver Control Panel is connected to this port with a green CAT-5 cable.

LED status lights – at the top of the 2 RJ45 ports

•

"POWER" (CPANEL): This indicator is lit when power is present at the POWER connector.

•

"POWER" (GPS): These indicators are lit when the system is turned ON (via the control panel or the PCON

connections).

•

"LINK" (all ports): These indicators blink to indicate data activity on the port.

LED status lights are provided on the RJ45 ports. All ports are electrically protected; therefore, if a "POWER"

indicator goes out when connecting a device to the head unit, then there is probably a fault with the device;

Relay Timer Options

The relay can be programmed to perform different functions when commentary has been manually played or

triggered via GPS. Various relay functions can be set via the "Relay Timer" setting in the Route Builder software

tool:

"ONE-SHOT": Connection closes once for 1 second at the beginning of each commentary. This

mode will be selected when the "Relay Timer" setting in Route Builder is set to '1'. This function

can be used to activate an external chime;

"FLASH": Connection alternately opens and closes once per second. Total duration is set by the

"Relay Timer" from '2' seconds to '59' seconds. This mode can be used to flash an external sign;

"OFF": Setting "Relay Timer" to '0' seconds deactivates the relay.