- ページ 5

モニター Acer 707のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Acer 707 5 ページ。 Acer computer monitor user guide

ページを印刷する

3.2 Signal connector pin assignment

4. Troubleshooting

If your monitor is not performing properly, use the following troubleshooting

for quick solutions to common problems, If the problem persists, call the

dealer. Where you purchased the monitor.

No Picture:

Please check these items

Power cord and signal cable are securely connected.

Monitor in power save mode?

Adjust the brightness and contrast controls.

Display image is too large or small:

Use the function keys to adjust the image.

Picture is scrolling or unstable:

l Signal cable should be completely attached to the computer.

l Check the signal cable pin assignments incorrect?

Color is abnormal:

l Magnetic object nearby?

l Signal cable pin assignments incorrect?

l Signal cable properly connected?

Image is not correctly shaped:

A new video mode is selected

User control has not yet been adjusted. Use the function keys to adjust

image.

Assignment

Red Video

No connection

Green Video

Ground

Blue Video

Ground

SDA For DDC

Ground

H. Sync.

Red Ground

V. Sync.

Green Ground

SCL For DDC

Blue Ground

Page 6

FEDERAL COMMUNICATIONS

COMMISSION(F.C.C)STATEMENT

This equipment has been tested and found to comply with the limits of a Class B digital

device. Pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

1. Reorient/Relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the manufacturer

responsible for compliance could void the user's authority to operate the

equipment.

NOTE: The use of a non-shielded interface cable with this equipment is prohibited.