- ページ 15

モニター Acer AC 711のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Acer AC 711 25 ページ。 Acer 17" monitor user manual ac 711
Acer AC 711 にも：ユーザーマニュアル (7 ページ), クイック・スタート・マニュアル (7 ページ)

ページを印刷する

4. POWER SUPPLY

A. RECTIFIER AND FILTER CKT:

The 90Vac-265Vac input line voltage is rectified by BD901, and smoothed by C906 to

provide DC operating voltage for the circuit.

B. FLYBACK AND PWM CKT :

When power is initially applied to the circuit,C909 charges through R903, Q902.When the

voltage across C909 reaches a level of 16V, U901 is enabled, turning on Q903 and turning

off Q902 to complete start-up action.

During the On-time of Q901, energy is stored in T900. At this time the polarity of the output

windings is such that all output rectifiers are reverse biased and no energy is transferred.

Primary current is sensed by R907 and compared to a DC level that is determined by voltage

feedback. When this level is reached, Q901 is turned off and the polarity of all T900

windings reverses , forward biasing the output rectifiers. All the energy stored is now

transferred to the output capacitors. Many cycles of this store/release action are needed to

charge the outputs to their respective voltages.

The voltage across C946 is fed through a voltage divider,R970, R971, R973, C975, R976,

R977 and VR901 to the error amplifier U904 compared to an internal 2.5V reference, then

determine the feed back level of U901 pin 1.

C. SNUBBER CKT:

Energy stored in the leakage inductance of T900 cause a voltage spike which be added to the

normal reset voltage across T900 when Q901 turn off. The clamp consisting of D905, R904

and C907 limits this voltage excursion from exceeding the Vds rating of Q901.

D. SYNCHRONIZED CKT:

The oscillator frequency is defined by R919, C916. The equation is approximately:

Fosc=1.8/ (R919*C916). The external signal "SYN & SYN "

E. POWER SAVING CKT:

The monitor has ON and OFF states. The monitor enters OFF mode if H-sync and/or V-sync

are removed. When in the OFF State, PS1 should below simultaneously to turn off +13.5Vs

outputs. PS2 should enter PWM Pulse to pre- CRT- heater. In this state, input power should

be less than 5W and LED-1 LED illuminate yellow.