- ページ 2

モニター Acer AF705のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Acer AF705 6 ページ。 Acer af705: user guide

Federal Communications Commission

( FCC Statement )

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

!" Reorientate or relocate the receiving antenna;

!" Increase the separation between the equipment and receiver;

!" Connect the equipment with a power socket on a circuit different from that to which the receiver is

connected;

!" Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturers may void the user's authority to

operate this equipment.

A shielded-type video signal cable is required in order to meet the FCC emission limits and also

to prevent interference to nearby radio and television reception. It is essential that only the

supplied power cord be used.

Use only shielded cables to connect I/O devices to this equipment.

Canadian DOC Notice

For Class B Computing Devices

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel

brouilleur du Canada.

Place the monitor with its tube down on

a stable surface.

Align the four tabs of the swivel base

with the slots in the bottom of the

monitor.

Insert the tabs into the slots of the

monitor

Now slowly slide the swivel base toward

the front of the monitor till you hear the

spring lock click into place.

If you need to remove the swivel base, push the spring lock and then pull the swivel base away from the monitor.

Special attention should be paid to the control knobs and LED indicators on the front panel

NOTE:

when you place the monitor with its tube down. This will prevent damage to these control knobs and

LED indicators from excessive pressure.