- ページ 2

扇風機 aero pure AP120-SのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。aero pure AP120-S 4 ページ。 Ventilation fan
aero pure AP120-S にも：マニュアル (5 ページ)

PLAN THE INSTALLATION

1. Do not use in a cooking area.

ASSEMBLY INSTRUCTIONS

1. Before installation, you need to know:

Note: Hanger bar short only can slide into channel A.

2.Mount with mounting holes and hanger bar

Slide one hanger bar into the channel on the housing and adjust to fit

between framing. Hold housing in place so that the housing contacts the

bottom of the joist. Screw housing to joist through hole A and hole B.

Screw the hanger bar onto the other side of joist through the hole (refer

to diagram at right). Screw hanger bar to housing with screw A.

Hanger Bar Options

Distance A

13 1/4 in to 15 1/2 in (336mm-394mm)

16 1/2 in to 18 7/8 in (419mm-480mm)

3.Mount with hanger bars only

Slide hanger bars onto housing and adjust to fit between framing.

Extend the hanger bars to the width of the framing. Holding the fan in

place, position the hanger bar tabs close to the bottom edge of the

framing. Secure hanger bars to framing using one screw on each end of

hanger bar (refer to the right diagram). Screw hanger bars to housing

with screw A.

Hanger Bar A Option

Distance A

14 in to 23 1/2 in (356mm-597mm)

21 1/4 in to 23 1/2 in (540mm-597mm)

4. Mount to I-joist

Slide one hanger bar (long) into channel B on the housing and adjust to

fit between framing. Hold housing in place so that the housing contacts

the bottom of the joist. Screw housing to joist through hole A and hole B.

Screw the hangar bar onto the other side of joist through the hole (refer

to diagram at right). Screw hanger bar to housing with screw A.

Hanger Bar

Channel

Hanger bar (short)

Channel A (Fig. 1)

Hanger bar (long)

Channel B (Fig. 2)

Hanger Bar A

Hanger bar (short)

Hanger bar (long)

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with the homeowner

2. Two ways to connect ductwork to a factory-shipped unit

Aero Pure AP 120-S, AP120H-S