- ページ 9
プリンター Canon 9316A009AAのPDF 簡易サービスマニュアルをオンラインで閲覧またはダウンロードできます。Canon 9316A009AA 24 ページ。 Desktop serial color bubble jet printer
ページを印刷する
4. SERVICE MODE
Function
Service test print
- Model name
- ROM version
- USB serial number
- Waste ink amount
- CD-R sensor correction
EEPROM initialization
Waste ink counter reset
Destination settings
Note: At the end of the service mode, press the Power button. To protect the media sensor from being
dislocated during transportation, the paper lifting plate of the sheet feeder unit will be raised.
<Service mode operation procedures>
1)
With the printer power turned off, while pressing the Resume/Cancel button, press and hold the
Power button. (DO NOT release the buttons. The LED lights in green to indicate that a function
is selectable.)
2)
While holding the Power button, release the Resume/Cancel button. (DO NOT release the
Power button.)
3)
While holding the Power button, press the Resume/Cancel button 2 times, and then release
both the Power and Resume/Cancel buttons. (Each time the Resume/Cancel button is pressed,
the LED lights alternately in orange and green, starting with orange.)
4)
When the LED lights in green, press the Resume/Cancel button the specified number of time(s)
according to the function listed in the table below. (Each time the Resume/Cancel button is
pressed, the LED lights alternately in orange and green, starting with orange.)
Times
LED
0 times
Green
1 time
Orange Service test print
2 times
Green
3 times
Orange EEPROM initialization
4 times
Green
5 times
Orange Destination settings
6 times
Green
7 times
Green
8 times
Orange CD-R print position correction
9 times
Green
10 times
or more
Procedures
See "Service mode operation
procedures" below.
See "Service mode operation
procedures" below.
See "Service mode operation
procedures" below.
See "Service mode operation
procedures" below.
Function
Power off
EEPROM information print
Waste ink counter resetting
Print head deep cleaning
CD-R test print
(horizontal)
CD-R print position correction
(vertical)
Return to the menu selection
Set a sheet of A4- , letter-, or larger-sized
paper.
For print sample, see APPENDIX 1, SERVICE
TEST PRINT, <Service Test Print Sample>.
The following items are NOT initialized:
- USB serial number
- Destination settings
- Waste ink counter
- CD-R correction value
If the waste ink amount is 7% or more,
replace the bottom case unit, or the ink
absorbers.
Other than Japan: iP3000
Japan:
When the print head is not installed, the carriage
returns and locks in the home position.
See APPENDIX 1, SERVICE TEST PRINT.
See APPENDIX 2, EEPROM INFORMATION
PRINT.
Proceed to the step 5), and follow the
Destination settings procedures.
Not used in servicing.
Not used in servicing.
Not used in servicing.
9
Remarks
iP3100
Remarks