- ページ 4

モニター Acer AL712のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Acer AL712 13 ページ。 17" (43 cm)
Acer AL712 にも：ユーザーマニュアル (9 ページ), マニュアル (10 ページ)

Connecting the LCD Monitor and Base

W h e n y o u o p e n t h e b o x t o t a k e t h e b a s e a n d p u t o n

t h e d e s k f i r s t . T h e n c o n n e c t t h e L C D M o n i t o r a n d

base please.(See fig.1- 1 )

T h e L C D M o n i t o r i s designed to allow users to have

a c o m f o r t a b l e v i e w i n g a n g l e . T h e v i e w i n g a n g l e c a n

be adjusted from - 5 °t o +3 0 °. (See fig. 1- 2 )

Warning

Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this

will result in damaging the Monitor and Monitor stand.

Unscrew screws Œ the swivel base support column and pull

down• the hinge to release.

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7

pitches threaded nuts, as well as four 5 mm access holes in the

plastic covering as illustrated in Figure 1-4. These

specifications meet the VESA Flat Panel Monitor Physical

Mounting Interface Standard (paragraphs 2.1 and 2.1.3,

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor's

VGA port or DVI port .(For AL712/AL713)(See Fig 1-5)

3. Connect the other end of the signal cable to the VGA port

or DVI port on your PC.

4. Make sure connection are secure.

Attention:

This device must be connected to an off-the-shelf video cable in order to comply with FCC

regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

Figure 1-1

Figure 1-2

Figure 1-3

Figure 1-4

Figure 1-5