- ページ 2

スイッチ AeroAudio MOS QUATRO IPのPDF マニュアルをオンラインで閲覧またはダウンロードできます。AeroAudio MOS QUATRO IP 11 ページ。

MOS QUATRO IP

MANUAL

The MOS Quatro IP is a four-way 19 inch microphone on-air switch for switching microphone

lighting on for example the Yellowtec Mika microphone arms.

The four microphone ports switch separately from each other.

The indication LED's on the front panel of the MOS Quatro IP shows the status of each microphone.

These LED's indicates whether the microphone arms are on standby, fixed white light, or fading in

and out.

The status LED tells You the status of the white lights. If this LED is on, the function of the white

lights are set for fading. If this LED is off, then the white lights are fixed.

Up to 4 microphone arms can be connected to the rear panel of the MOS Quatro IP. The MOS

Quatro IP will control the lights of the connected arms in red for on-air and white for off-air.

The audio signal is routed directly from the connected microphone arm to a standard 3-pin XLR

connector.

Connections from left to right

Power

9 to 18 volts DC

RJ11

Link connection for synchronisation with other MOS (Uno or Quatro)

Link1 = master and Link2 = slave

You need this link only when the white led's are set to fading (statusled is on)

To activate or deactivate this function see chapter "light settings" on page 5

ETHERNET

Ethernet network connection

It is best to ground the device or place the device in a rack that is properly earthed to prevent static

discharge, should this happen please reboot the device.

STEENWEG 148C - 9810 NAZARETH - BELGIUM - T +32 (0)9 396 76 40 - [email protected]