1.) Preparation and installation of the filters
The air purifier is equipped with all filters from the factory. First open the front filter cover by reaching into the side
ventilation slots at the upper end and pulling the filter cover forwards with a slight jerk. Now remove all filters.
Remove the protective cover from the fine filters and then insert the filters back into the unit in the correct order.
When inserting the filters, make sure that they are inserted properly so that the tab always faces forward/outward !
Finally, insert the pre-filter. Make sure that all the holders are properly seated in the pockets. Finally, replace the
front panel and close it.
See the charts below:
2.) The right location
Place the air purifier under the following aspects:
Central to achieving the highest possible effectiveness.
Near possible sources of dirt (windows, doors, pets, smokers).
With a minimum distance to the side of 50 cm and to the rear of
10 cm. (See diagram opposite).
To avoid interference, we recommend a distance of about one
metre from the TV and/or radios. In addition, the units should be
powered from different power sources.
Since the unit attracts dust, if the unit is always in the same
location, the surrounding (white) walls may become dirty more
quickly than in other areas.
Instructions for use:
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: [email protected]