- ページ 5

掃除機 American Sanders AVAC Q-10のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。American Sanders AVAC Q-10 20 ページ。

ページを印刷する

MODEL: AVAC Q-10

Congratulations on your purchase of an American Sanders AVAC Q-10

backpack vacuum. You have purchased a high quality commercial

vacuum cleaner with a tested and certified HEPA filter. For your safety

and continued satisfaction with this product, please read this owner's

manual carefully before using. For your information, all parts used in

the manufacturing of this vacuum cleaner meet or exceed rigid quality

control standards. We stand behind all our products and are available

to assist you with a knowledgeable and dedicated staff. If we can help

you in any way, please call Customer Service at 800-367-3550.

We also recommend that you visit our website www.americansanders.com

for the fastest most efficient way to complete your product registration

and see other products and accessories to meet your floor sanding and

finishing needs.

PREPARING THE VACUUM

INSPECTION

Carefully unpack and inspect your new vacuum for shipping damage.

Contents should be as shown.

HARNESS ASSEMBLY

Remove four (4) screws from vacuum housing inserts. Position harness

on vacuum housing. Align harness back plate with mounting holes

to the vacuum body. Re- insert four (4) screws through harness and

tighten.

ABOUT THE VACUUM

Loosen waist and chest belt latches. Slide arms through shoulder

straps. Adjust shoulder straps to raise or lower backpack so that the

weight is evenly distributed between the back and hips, and the waist

and chest belt latches comfortably. For significantly shorter or taller

operators, it may be necessary to adjust the harness back-plate to

find a comfortable position. The back-plate can be re-positioned by

removing and relocating the four (4) screws to the vacuum housing.

1) Pass the pigtail cord through the strap outside the left side of the

waist belt. Pass your extension power cord (not provided with vacuum)

through the plastic retaining clip hanging from the harness. This will

prevent the pigtail and extension power cord from separating during

operation.

(2) Place the pigtail switch box

under the sewn strap and fasten

the other strap around the

switch box.

(3) Fasten the waist belt and chest belt snugly and make sure the

weight is resting comfortably on your hips. Again, the back plate is

adjustable up or down by re- moving the four screws that attach to

the vacuum's body.

The motor in this vacuum is protected with a thermal cutoff device.

If an excessive high operating temperature is detected, power to the

motor will be cutoff. Excessive operating temperature can be caused

by a blocked vacuum hose or clogged filters. If thermal cutoff occurs,

immediately turn off the vacuum and inspect for hose blockage or full

filter bag. Remove blockage and/or replace filter bag, then allow about

45 minutes for the vacuum to cool down to reset thermal cutoff device

before turning vacuum on.

WARNING

• Unplug the vacuum when working on the motor or any electrical part.

• Check the condition of all electrical cords before each use.

• Do not lubricate the motor; it is equipped with sealed bearings.

• The vacuum has no user serviceable parts.

• Do not vacuum with a frayed, worn, or damaged cord.

• Do not vacuum liquids or expose the canister vacuum to rain

or water.

• Do not vacuum hazardous or toxic materials without HEPA filter

in place.

• Do not use to pick up liquids or flammable liquids.

ADJUSTING BACKPACK HARNESS

TO OPERATE

THERMAL PROTECTION