- ページ 2
ツール Air & Allied Sales TOKU DIGGER TCD-20のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Air & Allied Sales TOKU DIGGER TCD-20 12 ページ。
Safety precaution when using an Air Tool
Always obey the law and the safety regulations during work.
Always wear proper clothing and use other protective equipment when operating an air tool.
WARNING
Always wear ear protection to prevent possible ear damage when operating an air tool at high noise level or for
a long time.
WARNING
Heavy vibration from an air tool may result in injury to the hand, fingers and wrist of operator during a long
period of operation.
Stop using an air tool if you feel pain or any problem concerning the use of an air tool. Resume use of an air tool
after consulting with a doctor, confirming that there is no problem concerning the use of an air tool.
Always wear suitable working clothes when operating an air tool because a necktie or clothing with an open
sleeve may get caught in the air tool during operation and may result in danger to the operator.
Always wear the following protective equipment during the operation of an air tool to protect the operator from
getting hurt according to the type of the operation.
Gloves
Dust proof mask
Setting up a dust vacuum device is recommended when operating an air tool indoors.
Rules for the purpose of safety, which must be observed
WARNING
It is absolutely necessary to receive permission from the manufacture for the purpose of any modifications
concerning the air tool.
The manufacturer will not assume any responsibility concerning an accident resulting in injury, death or any
trouble from an air tool due to the reconstruction without the permission of the manufacturer.
Always use GENUlNE tool replacement parts recommended by the manufacturer when replacing any part of an
air tool.
There must be a sticker or a sign indicating matters concerning the safety precautions and maintenance on a
new air tool.
It is always important to keep this sticker of sign to be clean enough to read. It is available from the distributor
of the manufacturer if it is lost.
Checking the workplace or work site
Do not permit people except operators get near the work site. Especially it is very dangerous to permit children
into the working area.
Arranging and preparing the working area are the starting lines to ensure safety operation. Always maintain the
work site or workshop to be in order and make sure they have enough light.
Always observe the rules such as warning, caution, manual, etc written in the working area.
Do not use the tool in explosive conditions.
Maintenance and replacement of the chisel
WARNING
Turn the valve cock of the compressor completely to the stop position, hold down the throttle valve and release
the pressure in the hose completely before inspecting and replacing the chisel.
Inspect the chisel regularly, replace with a new one if any defect, such as a crack is found. Using a chisel with
any defect is very dangerous.
Make sure that the tip of the chisel is sharp once again.
Helmet
Protective goggles
2
Air & Allied Sales (Pacific) Pty Ltd
Ear protection
Working shoes
www.air-allied.com.au