- ページ 7
超音波ジュエリークリーナー Bobot WIN SPIDERのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bobot WIN SPIDER 8 ページ。 Window cleaner
ページを印刷するTroubleshooting
Malfunction
The device gets slippery or
works in irregular pattern.
Red indicator light.
The devices can't be started
after switched on, or works in
irregular pattern.
buzzer beeps once/second .
Both Red and Blue indicator
Remote control does not work.
The device got stuck on glass
frames.
Both Red and Blue Light on, no
beeps.
Buzzer beeps twice when it's in
use.
Squeaky sound when it's in
use.
The device doesn't return to
Starting Point after cleaning.
11
Possible Causes
A. Glass is too dirty or too wet.
B. Cleaning pad is too dirty or too
wet.
Edge detection sensor abnormal.
Improper connection of Power
Supply.
Hardware failure.
A. No battery inside or battery has
low power;
B. Remote control is broken.
Edge-detection misjudgement.
The device is not sucking
properly on window.
Edge sensor detects frameless
glass.
Glass is too dry or edge detection
sensors are too dirty.
The glass surface 's friction index
Solutions
A.Change cleaning pad
B. Cleaning the driving treads
C. Use remote control to manually restart it.
A. Check if the cleaning pad is attached properly, replace it
correctly.
B. Check if any crack on the glass.
C. Check if the glass frames are with uneven area/rubber
part. If there is
uneven area or uneven rubber part on the glass, use remote
control to
operate the device manually and keep the W 120 away from
the
uneven area/uneven rubber part when cleaning.
A. Remove the Cleaning Pad and reattach
it making sure it is placed exactly within its Velcro area and
does not
cover the Edge Detection Sensors.
B. Open APP on your phone, connect it with the robot and
any RED indications on the corners of APP interface (Red
indications on
the APP interface means the edge sensor is malfunctioned).
C. Edge detection sensors failure, contact after-sales service.
Check if the plug is connected well, or the screws of the
extension cables are placed tight.
Contact after-sales service.
A. Change the battery.
B. Replace the remote control with new one.
A. Press STOP on remote, move the device to reachable
B. Pull the robot lightly to reachable location if can't remote
control it.
Put the device on window surface manually, make sure it
sucks on the window properly.
It's normal if it is cleaning frameless glass.
A. Spary a little water on the cleaning cloth.
B. Clean the edge detection sensors and operate again.
Use remote control to direct the device return to reachable
location.