- ページ 8

ウォーター・ディスペンサー Euro-Clear BlueSoft 1354EA-RXのPDF メカニック・マニュアルをオンラインで閲覧またはダウンロードできます。Euro-Clear BlueSoft 1354EA-RX 15 ページ。 Iron, manganese, ammonia and other natural organic matter removers, water softeners with ecomix media

ページを印刷する

Euro-Clear Kft.

Water purification and treatment equipment manufacturer and wholesale distributor

Tel: +36 96 544-240 • Fax: +36 96 544-248 • E-mail: [email protected] • Web: www. euro-clear.eu

4.3.1. WATER PRODUCTION

During water production, the water gets into the column through the upper filter and it

flows through the charge to remove iron from up to down while the divalent iron ions

get oxidized and filtrated. The iron free water gets out of the device through the lower

filter.

4.3.2. BACKWASH

During backwash the water gets into the column through the lower filter and it flows

through the charge from down to up. Meanwhile, the filtrating charge gets stirred up

and the iron residual gets removed. The water for backwash gets out into the

channel through the drain.

4.3.3. DOWNFLOW WASHING

During the downflow washing the water gets into the upper filter into the column to

store charge and it flows through the charge from up to down. It goes into the

channel through the drain.During the downflow washing the recompression of the

filtrating charge that has been stirred up is done.

4.4. DETAILED DESCRIPTION OF THE OPERATION CONTROL

The automatical blocked valve is solely time controlled during the operation and all

the other working processes. There is an electronic clock for metering time. Apart

from metering time, this clock gets the mechanisme of the blocked valve to work.

The control unit has been programmed during production, the time for backwash is 2

o'clock at night. The backwash lasts for ~20 minutes. The frequency of backwash

can be programmed between 1-99 days, depending on the system's needs.

5. INSTALLATION AND SETTING-UP OF THE DEVICE

5.1. CONDITIONS OF INSTALLATION:

A room with flat, horizontal and hard flooring is needed for the installation of the

device. The flooring and the direct surroundings of the device must resist to the

corrosive effect of the brine. The device must be installed in a room the temperature

of which is between +5°C to +40°C. The temperature of the raw water to be treated

must not exceed +30 °C. The device must not be installed in a strongly damp or

dusty room. It must be protected from frost, radiant heat and ultraviolet radiance.

Near the device, sewage connection and 230 V 50 Hz grounded, electric socket

must be provided. In order to diminish risks, we advise to install the device into a

room provided with floor drainage.

Below water pressure of 2,5 bars, proper regeneration is not guaranteed, so in this

case we advise to build in a device to increase pressure.

BlueSoft Industrial Iron and Manganese Remover

Page 8.