- ページ 3

プリンター Boca Systems LEMUR-XのPDF インストールをオンラインで閲覧またはダウンロードできます。Boca Systems LEMUR-X 4 ページ。

Tear off a full turn of the paper from the new paper roll. Caution: This is important as the outer end of

the paper is usually secured to the roll with glue or other adhesive substance that may cause paper jam

or damage the print head.

Place the Receipt roll onto the spindle. If the thermal side of the media is towards the outside of the

10.

roll, the roll will turn towards the printer (as shown in the photo below). If the thermal side of the media

is towards the inside of the roll, the roll will turn away from the printer.

Install the stopper disc onto the spindle and slide into place. The stopper should be positioned to prevent

11.

the roll from moving too much from side to side but be allowed to spin freely.

Once you have the stopper in the desired position, tighten the Philip head screw to hold the stopper in

12.

place.

Once the stopper disc is in place it should not be necessary to remove it to install or remove a roll, provided

13.

the roll core inner diameter is 1.0" or greater. The core should slip over the disc.

If the roll holder has been configured for use with 58mm center infeed guide you will want to run the printer

14.

to ensure media is feeding properly into the printer. If not then make necessary adjustment to the roll

holder block and stopper disc for proper alignment with the printer.

Must be

completely

removed

Stopper

Disc

Philip head

screw

Stopper

Disc