- ページ 8

扇風機 Domus HOVER-56のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Domus HOVER-56 19 ページ。

Control Module And Handset Programming Explanation

*HANDSET PROGRAMMING ONLY NEEDED WHEN GETTING NEW HANDSET

MAKE SURE THE ISOLATION SWITCH IS ON OR REMOTE CONTROL WILL NOT WORK

Handset Battery Installation/Replacement

Open the battery compartment by pushing the cover away from you. UNWRAP THE PLASTIC FROM AROUND NEW BATTERIES

(if wrapped). Observe Polarity and make sure battery sits properly in recess. Slide the cover back into place.

How To Add a Replacement Handset

The receiver can learn the identification code for a new handset using the following procedure:

a. Turn off power to fan at isolation / wall switch and wait for 30 seconds then turn power back on at the isolation / wall switch, the

fan will beep once.

b. Press and hold the "Forward/Reverse" button until you hear one beep from the receiver. The remote will then be linked to the fan.

Two handsets can be paired to each fan, and the same handset can control multiple fans.

How To Add an accessory 240V DC Wall Controller (sold separately)

The receiver can learn the identification code for a new DC wall controller using the following procedure:

c. Turn off power to fan at isolation / wall switch and wait for 30 seconds then turn power back on, the fan will beep once.

d. Press and hold the "Forward/Reverse" button for 5 seconds until the fan beeps once. The DC Wall Controller will then be linked to

the fan. Either two remote handsets or one remote handset combined with one DC Wall Controller can be paired per fan and can

control a maximum of two ceiling fans.

• Please note maximum two ceiling fans using one DC wall controller. Both fans must have their own receiver and the wall controller must be

installed in the same room as the fans.

• If the 240V DC Wall Controller is fitted, there will only be 6 speeds and 6 settings of dimming available. No LED colour changing available

via the 240V DC Wall Controller, this is only via the remote handset. The 9 speed handset will still have all the functions.

NOTE: THE MAINS POWER TO THE CONTROL MODULE MUST BE SWITCHED ON-OFF VIA AN ISOLATION SWITCH.

NOT THE BUTTONS ON THE HANDSET.

SEE TERMS AND CONDITIONS OF WARRANTY. YOU WILL BE CHARGED A SERVICE FEE IF THE PRODUCT IS NOT

DEFECTIVE OR IS DAMAGED BY POWER SURGES, LIGHTNING, WEATHER, MISUSE/ABUSE AND SIMILAR SITUATIONS.

ALL INSTALLATION INSTRUCTIONS MUST BE FOLLOWED.

POWER OUTLETS OR FIXED WIRING MUST BE INSTALLED BY A LICENSED ELECTRICIAN

To protect your customer's WARRANTY please READ PAGE 2 of this booklet prior to the installation of this product.

Installation Manual

Date: November 18, 2022 10:25 am