ページを印刷する
V E N T I L A T I O N
Press the "+" and "-" buttons to move along the timeline at the bottom of the screen; a
block will be added to each position.
To remove a block, remove the word "BYPASS" from the screen by pressing "BYPASS"
and press the "+" and "-" buttons to move along the timeline at the bottom of the screen; a
block will be removed from each position.
Daily 'timeline patterns' can be copied to another day or multiple days to avoid
programming each day individually.
From the home screen, press "COPY"
Select the day to copy by pressing "PROG" (the day number will be displayed) and then
the day to copy-to by pressing the "+" and "-" buttons (the day number will flash). When
the two correct days have been selected, press "COPY" and the timeline pattern will copy
across.
Press "SET" to record
Filter reminder
The word 'Filter' will appear on the home screen after the set time has elapsed. When this
occurs, clean the filters (see section 6)
Note: The figure at the bottom of the screen indicates elapsed operating time in hours.
When the numbers are not flashing, they indicate the elapsed time since the last filter
reset. If "DAY" is pressed, the numbers will flash and indicate the total elapsed operating
time in hours.
To reset the filter elapsed time reminder following cleaning, press and hold "SET" for 5
seconds.
LAB1306R, Issue 1, March 2018
Page 11