- ページ 2
室内装飾品 American Standard Retrospect Washstand 9422.020のPDF 組み立て/設置手順をオンラインで閲覧またはダウンロードできます。American Standard Retrospect Washstand 9422.020 3 ページ。 Retrospect washstand
ページを印刷する
1
WASHSTAND ASSEMBLY
Thread the two legs with tapered upper ends into the threaded
holes at the front of the cabinet. Thread the remaining legs
into the two holes at the rear of the cabinet. Hand-tighten
each of the four legs.
2
SINK AND WASHSTAND INSTALLATION
Note: If replacing an existing sink be certain to shut
off water supply before removing old sink. If installing
in a new bathroom follow rough-in diagram to locate
rough supply, waste lines.
Provide suitable reinforcement behind finished wall for
sink hanger screws. For an installed sink height of
36", center the reinforcement 29" above the floor.
3
1) Move washstand into approximate position near the wall.
2) Place sink on washstand, aligning the tapered ends of the front legs with
the recesses in the underside of the front of the sink.
3) Place a level on the cabinet and use the four independently adjustable
washstand feet to level the assembly both side-to-side and front-to-back.
4) Place the level on the sink. If adjustment is required, either front-to-back or
side-to-side, remove the sink, place one or more of the adhesive-backed
cushions on the top surfaces of any of the legs as appropriate, and
replace the sink to verify.
5) Move the assembly into contact with the wall.
6) With a pencil, mark through the center of the two mounting holes found on
the back of the sink. See VIEW "A".
7) Move the assembly well clear of the wall.
8) Drill two pilot holes at the center marks using a 1/4" bit. Bore in 1" deep.
9) Thread the two 5/16" headless hanger screws into the pilot holes leaving
1-7/8" thread exposed in front of the wall.
4
Following manufacturer's instructions, install faucet and
drain assembly (not included) in sink. Be certain to apply
a bead of sealing putty on the underside of the drain to
ensure a watertight seal between the sink and the drain.
Remove excess putty immediately after tightening drain.
Move the assembly back toward the wall, guiding the
sink over the two headless hanger screws. Place
washers over studs and firmly hand-tighten nuts onto
each.
C/L of 2 x 8
Support
and Bracket
Finished
Floor
With lavatory in
place mark the
two mounting
hole locations.
Lavatory
- 2 -
Back
29"
VIEW "A"
VIEW "A"
Feet are
adjustable
Front Leg
Hanger Screw,
of Washstand
Washer & Nut
Front
7 3 0 8 0 4 - 1 0 0